CO2 laser cutting machine dimming steps

Date：2024-01-15 Source: This website

As we all know, CO2 laser cutting machine optical path is a hard optical path, reflected by the lens to the laser cutting head, so in the process of use, often because of vibration or other factors lead to the deviation of the optical path, resulting in poor cutting effect, below we explain the adjustment method and steps of the optical path in detail for the reference of our customers.

Light output diagram

1, to ensure that the light emitted by the laser tube in the center of the mirror 1.

2. Paste double-sided tape on the reflector 2 target, move the beam to the nearest position from the reflector 1, emit light according to the point (power adjustment is moderate, not too large or too small), and mark (special note: for

To prevent the laser radiation from injuring people, please first use a piece of paper board to test the general position of the light spot, but then proceed to adjust).

3, move the beam to the farthest position from the reflector 1, press the point, and make a mark, if the two marks do not coincide, adjust the reflector 1, and then step 2.3 repeat until the two mark positions coincide completely, and then lock the reflector adjusting screws and nuts.

4. Paste double-sided tape on the mirror 3, move the laser head to the closest position from the mirror 2, shoot according to the point, and mark

5, then move the cutting head to the farthest position from the reflector 2, press the point to shoot, mark, if the two marks do not coincide, adjust the reflector 2, and then step 4.5 repeat until the two mark positions coincide completely, and then lock the reflector adjusting screws and nuts.

6. Attach the double-sided tape to the laser cutting mouth, shoot according to the point, and then remove the cutting mouth part, look at the position of the mark point in the nozzle, remember to pay attention to the direction when looking.